NASM2259/2 Mil-Spec Composite Grommet Edging | Fits 0.059 – 0.74 inch panels PP KIT SO MRL and mod 8 encoders with

and mod 8 encoders with serial numbers 2

This IFR training Foggle (EDMO# 6162) is made of a yellow polycarbonate plastic

sunlight readable

The Model M1435-EXP provides 14-volt DC power for:Avionics demonstration and testingDatabase and firmware updatesFlight planning and cockpit procedures trainingTroubleshooting & maintenancePowered pre-flight inspections and battery top-offThis M-Series Mini-GPU (EDMO# M1435-EXP) includes a 6-foot airframe output cable with a yellow SB50 connector that protect from damage due to accidental voltage mismatch

NASM2259/2 Mil-Spec Composite Grommet Edging | Fits 0.059 – 0.74 inch panels PP KIT SO MRL and mod 8 encoders withSpring Fast Mil Spec composite grommet edging is designed for the high performance needs of the defense industry for use on airframes, tactical vehicles & ground based electronics. Grommet Edging is FAA Approved and installs in seconds and allows for immediate wire routing no adhesive curing, clean up, or inspections. The NASM2259 2 series features an abrasion resistant subsurface and a polymer cushion to provided a soft surface for protecting wires